2021-10-07 16:28:36 by Nia Alarie | Files touched by this commit (458) |
Log message: math: Remove SHA1 hashes for distfiles |
2021-05-24 21:56:06 by Thomas Klausner | Files touched by this commit (3575) |
Log message: *: recursive bump for perl 5.34 |
2020-08-31 20:13:29 by Thomas Klausner | Files touched by this commit (3631) |
Log message: *: bump PKGREVISION for perl-5.32. |
2020-08-17 22:20:41 by Leonardo Taccari | Files touched by this commit (2202) |
Log message: *: revbump after fontconfig bl3 changes (libuuid removal) |
2020-08-10 01:12:13 by Joerg Sonnenberger | Files touched by this commit (7) |
Log message: Don't leak tools-perl into config file. Bump revision. Avoid LOCALBASE and similar clean-up. |
2020-05-22 19:45:24 by Roland Illig | Files touched by this commit (1) | |
Log message: math/pari: clean up REPLACE_PERL Two of the files now use autoconf to insert the correct Perl interpreter. The dependency "pre-install: replace-interpreter" was useless since then replace-interpreter would be run once in a direct "bmake update" or "bmake install", and twice in bulk builds since they first run "bmake build" and then "bmake install". And even in the latter case, \ replacing the interpreter twice had no effect since it was already replaced in the configure phase. |
2020-05-02 15:37:08 by Roland Illig | Files touched by this commit (1) |
Log message: math/pari: remove no-op SUBST block When building on NetBSD-8.0-x86_64, the file pari.cfg does not contain any references to TOOLS_DIR. |
2020-01-26 18:32:28 by Roland Illig | Files touched by this commit (981) |
Log message: all: migrate homepages from http to https pkglint -r --network --only "migrate" As a side-effect of migrating the homepages, pkglint also fixed a few indentations in unrelated lines. These and the new homepages have been checked manually. |
2019-08-11 15:25:21 by Thomas Klausner | Files touched by this commit (3557) |
Log message: Bump PKGREVISIONs for perl 5.30.0 |
2018-08-22 11:48:07 by Thomas Klausner | Files touched by this commit (3558) |
Log message: Recursive bump for perl5-5.28.0 |